Carl Goldberg GBGA1089 - Manual (Page 18)

18
Remove
3. Place the windshield onto the front of the fuse-
lage.
Using a pencil, mark where the windshield
over lap's the side of the fuselage where the
wing will fit.
11. Cut the plastic till it is flush with the side of the
fuselage and so that the wing will fit flush
against the fuselage.
Once satisfied with the fit glue the windshield
in place using a canopy glue.
Tape the windshield to the fuselage till dry.
BOLTING ON THE WING
† Gather the following items
(1) Right & Left Wing Panels
(2) 1/4-20 x 2” Nylon Bolt
(1) Wing Tube
† Slide the wing tube into one of the wing
halves.
† Slide the tube thru the fuselage.
† Slide the second wing half onto the wing tube
coming out of the fuselage side.
† Push the two wing halves together till they ar
tight against the fuselage side.
† Bolt the wing to the fuselage using a 1/4-20
nylon bolt.
TOP HATCH
1. Collect the following items:
(1) 5-1/8” x 7-7/8”Clear plastic
(4) 4-40 x 1/2 socket head screws
(1) Clear vinyl tape
2. † Remove the covering over the four holes in
the rear of the hatch opening.
† Tape the front of the 5-1/8” x 7-7/8” Clear
plastic .flush with the edge of the front wind-
shield.
† Mark each of the hole locations in the rear of
the plastic hatch.
† Drill a 1/8” hole at each of the marks.
† Using the 4-40x 1/2 socket head bolts attach
the hatch to the fuselage.
Clear Vinyl Tape
WING STRUTS
1. Collect the following items:
(2) Wing Struts
(6) 2-56 Golden Clevises
(6) 2-56 Hex nuts
(6) Clevis Clips
Front
2. † Install a 2-56 hex nut then a golden clevis on
each of the ends of the wing strut.