Carl Goldberg GBGA1089 - Manual (Page 14)

14
INSTALLING THE ENGINE
1. Collect the following items:
(2) Motor Mounts
(1) Engine
(4) #10 x 3/4” sheet metal screw
(10) 8-32 x 1” Philip Head Screw
(10) #8 Washer
(1) 3mm x 430mm Tubing
(1) 1.5mm x 490mm wire
(1) swivel-Keeper
(1) Pushrod Connector
(1) Snap Nut
(1) 4-40 x 1/8 Socket Head Screw
(1) Wood firewall spacer
(4) 8-32 Blind Nut
INSTALLING FUEL TANK
1. † Gather the following items
(1) Foam Rubber (Not Included)
(1) Fuel tank tray
(1) Fuel tank
2.
Cut a piece of foam to fit under the fuel tank.
Mount the fuel tank on to the fuel tank tray
using velcro or rubber bands.
Fit the fuel tank into the fuselage
Fuel
Notch in cross brace
Fuel tank tray tab locations
Insert the front tabs into the firewall.
Fit the rear of the tray in the notch of the cross
brace.
Glue in place.
2.
Place you engine in the mounts and adjust till
the prop drive washer is 5-3/4” from the fire-
wall. Clamp the engine in place and and mark
the location of the mounting holes. Drill using
a 1/8” bit.
Screw the engine onto the motor mount using
the #8 x 1” screws.