Driving and operating 9-51 – CHEVROLET 2012 Avalanche User Manual

Page 301

Advertising
background image

Black plate (51,1)

Chevrolet Avalanche Owner Manual - 2012 - crc 2nd edition - 11/7/11

Driving and Operating

9-51

WARNING (Continued)

To prevent injury, death,
or vehicle damage, even with
URPA, always check the area
around the vehicle and check
all mirrors before backing.

How the System Works

URPA comes on automatically
when the shift lever is moved into
R (Reverse). A single tone sounds
to indicate the system is working.

URPA operates only at speeds less
than 8 km/h (5 mph).

An obstacle is indicated by audible
beeps. The interval between the
beeps becomes shorter as the
vehicle gets closer to the obstacle.
When the distance is less than
30 cm (12 in) the beeping is a
continuous tone for five seconds.

To be detected, objects must be at
least 25 cm (10 in) off the ground
and below tailgate level. Objects

must also be within 2.5 m (8 ft) from
the rear bumper. This distance may
be less during warmer or humid
weather.

Turning the System On and Off

The URPA system can be turned on
and off using the rear park aid
disable button located next to the
radio.

The indicator light comes on when
the system is disabled and turns off
when the system is on.

When the system is off, PARK
ASSIST OFF displays on the Driver
Information Center (DIC). The
message disappears after a short
period of time.

URPA defaults to the on setting
each time the vehicle is started.

Notice: If you use URPA while the
tailgate is lowered, it may not
detect an object behind your
vehicle, and you might back into
the object and damage your
vehicle. Always verify the tailgate
is closed when using URPA or
turn off URPA when driving with
the tailgate lowered.

When the System Does Not
Seem to Work Properly

The following messages may be
displayed on the DIC:

SERVICE PARK ASSIST: If this
message occurs, take the vehicle to
your dealer to repair the system.

PARK ASST BLOCKED SEE
OWNERS MANUAL:
This
message can occur under the
following conditions:

.

The ultrasonic sensors are not
clean. Keep the vehicle's rear
bumper free of mud, dirt, snow,
ice, and slush. For cleaning
instructions, see Exterior Care
on page 10‑89
.

Advertising