CHEVROLET 2011 Silverado - Manual (Page 11)

Black plate (3,1) Silverado/Sierra Hybrid - 2011
Storage 4-3
Closing the Cover
1. Release both the retention
straps located on the top of the
cover behind the cab and press
into the stored position.
2. Unfold the tonneau cover to the
closed position.
3. Lower the rear set of clamp
assemblies from the stored
position.
4. Tilt the clamp assembly so that
the locator is in the slot, pull
down on the assembly, and slide
the clamp under the edge of the
inner lip on the bed rail.
5. Pull the handle toward the rear
of the truck to engage the clamp.
Make sure the locator is secured
into the slot (A). If unable to
completely engage clamp, see
the tightening and loosening
procedures later in this section.
6. The clamp should be securely
engaged. Shake the handle
assembly to make sure the
handle does not move.
7. Repeat the clamp attachment
steps 3 through 6 for the
opposite side.
8. Close the endgate.