Instruments and controls 5-15 – CHEVROLET 2011 Aveo User Manual

Page 127

Advertising
background image

Black plate (15,1)

Chevrolet Aveo Owner Manual - 2011

Instruments and Controls

5-15

The following can prevent more
serious damage to the vehicle:

.

Reduce vehicle speed.

.

Avoid hard accelerations.

.

Avoid steep uphill grades.

If the light continues to flash, when
it is safe to do so, stop the vehicle.
Find a safe place to park the
vehicle. Turn the vehicle off, wait at
least 10 seconds, and restart the
engine. If the light is still flashing,
follow the previous steps and see
your dealer for service as soon as
possible.

Light On Steady: An emission
control system malfunction has
been detected on the vehicle.
Diagnosis and service might be
required.

The following may correct an
emission system malfunction:

.

Make sure the fuel cap is fully
installed. See Filling the Tank on
page 9‑37
. The diagnostic
system can determine if the
fuel cap has been left off or
improperly installed. A loose or
missing fuel cap allows fuel to
evaporate into the atmosphere.
A few driving trips with the cap
properly installed should turn the
light off.

.

Make sure the electrical system
is not wet. The system could be
wet if the vehicle was driven
through a deep puddle of water.
The condition is usually
corrected when the electrical
system dries out. A few driving
trips should turn the light off.

.

Make sure to fuel the vehicle
with quality fuel. Poor fuel quality
causes the engine not to run as
efficiently as designed and may
cause: stalling after start-up,
stalling when the vehicle is
changed into gear, misfiring,
hesitation on acceleration,
or stumbling on acceleration.
These conditions might go away
once the engine is warmed up.

If one or more of these
conditions occurs, change the
fuel brand used. It will require at
least one full tank of the proper
fuel to turn the light off.

See Recommended Fuel on

page 9‑35.

If none of the above have made
the light turn off, have your dealer
check the vehicle. The dealer has
the proper test equipment and
diagnostic tools to fix any
mechanical or electrical problems
that might have developed.

Advertising