CHEVROLET 2011 Aveo - Manual (Page 36)

Black plate (4,1) Chevrolet Aveo Owner Manual - 2011
2-4 Keys, Doors and Windows
K (Unlock): Press to unlock
all of the doors. The hazard
lamps flash twice to indicate that
unlocking has occurred and that
the theft-deterrent system is
deactivated. If the doors are not
opened within 30 seconds, the
doors will lock again.
3
(Panic) (Hatchback): Press to
sound the panic alarm. The hazard
lamps will flash and the panic alarm
will stay on for about 30 seconds.
Press any of the buttons on the
transmitter to turn off the alarm.
V
(Remote Trunk Release)
(Sedan): Press and hold for
approximately one second to open
the trunk.
The LED light (A) on the transmitter
flashes when the buttons on the
transmitter are pressed. If the light
does not flash, see “Battery
Replacement” in this section.
The buttons do not operate and the
theft-deterrent system does not
activate if the key is in the ignition.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to the vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
When the replacement transmitter
is programmed to the vehicle, all
remaining transmitters must also be
programmed. Any lost or stolen
transmitters no longer work once
the new transmitter is programmed.
Each vehicle can have up to
five transmitters programmed to it.
Battery Replacement
Replace the battery if the LED on
the transmitter does not flash when
you press the buttons.
Notice: When replacing the
battery, do not touch any of the
circuitry on the transmitter. Static
from your body could damage the
transmitter.
To replace the battery:
1. Remove the screw from the back
of the cover and open the cover
of the transmitter.
2. Pull the transmitter out of the
cover and carefully turn the
circle cover of the transmitter
unit toward open.
3. Remove the battery.
4. Insert the new battery, positive
side facing up.
Use one three-volt, CR1620,
or equivalent, type battery.
5. Turn the circle cover of the
transmitter unit toward close and
put the transmitter unit in the
cover.
6. Put the two halves back together
and replace the screw. Make
sure the cover is on tightly, so
water will not get in.
7. Test the transmitter operation.