Engine oil, Engine oil -18, Checking engine oil – CHEVROLET 2010 Silverado User Manual

Page 462: When to add engine oil

Advertising
background image

Engine Oil

For diesel engine vehicles, see “Engine Oil” in the
DURAMAX

®

Diesel manual.

Checking Engine Oil

It is a good idea to check the engine oil level at each
fuel fill. In order to get an accurate reading, the oil must
be warm and the vehicle must be on level ground.

The engine oil dipstick handle is a yellow loop. See
Engine Compartment Overview on page 6‑16 for the
location of the engine oil dipstick.

1. Turn off the engine and give the oil several minutes

to drain back into the oil pan. If this is not done, the
oil dipstick might not show the actual level.

2. Pull out the dipstick and clean it with a paper towel

or cloth, then push it back in all the way. Remove it
again, keeping the tip down, and check the level.

When to Add Engine Oil

If the oil is below the cross-hatched area at the tip
of the dipstick, add at least one liter/quart of the
recommended oil. This section explains what kind of
oil to use. For engine oil crankcase capacity, see
Capacities and Specifications on page 6‑126.

Notice: Do not add too much oil. If the engine
has so much oil that the oil level gets above the
cross-hatched area that shows the proper operating
range, the engine could be damaged.

6-18

Advertising