Dic warnings and messages, Dic warnings and messages -48 – CHEVROLET 2010 HHR User Manual

Page 208

Advertising
background image

AV (Average) SPEED

Press the information button until AV SPEED displays.
This mode shows the vehicle’s average speed in
miles per hour (mph) or kilometers per hour (km/h).

To reset the average vehicle speed, press and hold the
reset button while AV SPEED is displayed.

OIL LIFE

Press the information button until OIL LIFE displays.
The engine oil life system shows an estimate of the oil’s
remaining useful life. It shows 100% when the system
is reset after an oil change. It alerts you to change the oil
on a schedule consistent with your driving conditions.

In addition to the engine oil life system monitoring the oil
life, additional maintenance is recommended in the
Maintenance Schedule in this manual. See Engine Oil
on page 6-19 and Scheduled Maintenance on page 7-3.

Always reset the engine oil life system after an oil
change. See “How to Reset the Engine Oil Life System”
under Engine Oil Life System on page 6-23.

COOLANT

Press the information button until COOLANT displays.
This mode shows the temperature of the engine coolant
in either degrees Fahrenheit (°F) or degrees Celsius (°C).

Tire Pressure

If your vehicle has a Tire Pressure Monitor System
(TPMS), the pressure for each tire can be viewed in the
DIC. The tire pressure is shown in either pounds per
square inch (psi) or kilopascals (kPa). Press the
information button until LF ## PSI (kPa) ## RF displays
for the front tires. Press the information button again
until LR ## PSI (kPa) ## RR displays for the rear tires.

If a low tire pressure condition is detected by the system
while driving, a message advising you to check the tire
pressure appears in the display. See Inflation - Tire
Pressure
on page 6-62 and DIC Warnings and Messages
on page 4-48 for more information.

DIC Warnings and Messages

These messages appear if there is a problem detected
in one of your vehicle’s systems.

A message clears when the vehicle’s condition is no
longer present. To acknowledge a message and clear it
from the display, press and hold any of the DIC buttons.
If the condition is still present, the warning message
comes back on the next time the vehicle is turned
off and back on. With most messages, a warning chime
sounds when the message displays. Your vehicle
may have other warning messages.

4-48

Advertising