CHEVROLET 2010 HHR - Manual (Page 339)

To disconnect the jumper cables from both vehicles:
1. Disconnect the black negative (
−
) cable from
the vehicle that had the dead battery.
2. Disconnect the black negative (
−
) cable from the
vehicle with the good battery.
3. Disconnect the red positive (+) cable from the
vehicle with the good battery.
4. Disconnect the red positive (+) cable from the other
vehicle.
5. Return the positive (+) terminal cover to its original
position.
Headlamp Aiming
The vehicle has a visual optical headlamp aiming
system. The aim has been preset at the factory and
should need no further adjustment.
However, if the vehicle is damaged in a crash, the
headlamp aim may be affected and adjustment may be
necessary.
If oncoming vehicles flash their high beams at you, this
may also mean the vertical aim needs to be adjusted.
It is recommended that the vehicle is taken to your
dealer/retailer for service if the headlamps need to be
re-aimed. It is possible however, to re-aim the
headlamps as described.
The vehicle should:
• Be placed so the headlamps are 25 ft. (7.6 m) from
a light colored wall.
• Have all four tires on a level surface which is level
all the way to the wall.
• Be placed so it is perpendicular to the wall or other
flat surface.
• Not have any snow, ice, or mud on it.
• Be fully assembled and all other work stopped while
headlamp aiming is being performed.
• Normally loaded with a full tank of fuel and one
person or 160 lbs (75 kg) sitting on the driver seat.
• Have all tires properly inflated.
• Have the spare tire is in its original location in the
vehicle.
6-45