Crestron electronic C2N-TFM - Manual (Page 11)

Crestron C2N-TFM FM Radio Tuner
Operations Guide - DOC. 6233A FM Radio Tuner: C2N-TFM • 7
In the preset mode, the up/down buttons let you sequence through the preset numbers
(1-20) to select a station or to save a new station in a preset location.
In the tune mode, the up/down buttons let you sequence through the band frequencies
in 100 kHz increments (50 kHz increments when Europe mode is enabled).
In the scan mode, the up/down buttons initiate the scan and direction of the search for
the next station with a signal strong enough for good reception. Pressing either button
will halt the scan.
SAVE Button
Use the SAVE button to save a station frequency in a preset location. To save a preset,
select the desired station, use the MODE switch to select the preset mode, use the
up/down buttons to select the preset location, and then press SAVE. The display will
briefly show “SAVE” as the preset is saved.
SETUP LED and Pushbutton
The C2N-TFM is Touch Settable ID (TSID) ready. The SETUP pushbutton and its
associated LED are located on the rear panel and are used for setup of the unit’s
network ID during the initial configuration of a Cresnet system or when the device is
being added/replaced. Refer to “Method B (Touch Settable IDs)” on page 10
for
detailed information.
Industry Compliance
As of the date of manufacture, the C2N-TFM has been tested and found to comply
with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) these devices may not cause harmful interference,
and (2) these devices must accept any interference received, including interference
that may cause undesired operation.