Crestron electronic C2N-TFM - Manual (Page 42)

FM Radio Tuner Crestron C2N-TFM
38 • FM Radio Tuner: C2N-TFM Operations Guide - DOC. 6233A
3. As shown after this step, select the Net ID of the C2N-TFM and then
click OK. The “Open” window appears (refer to the subsequent
graphic).
“Select Network ID” Window
NOTE: When transferring any Cresnet file (touchpanel project/firmware), lower the
port speed baud rate to 38400 to match the Cresnet bus speed.
“Open” Window
4. Browse to the desired .upg file and click Open to begin the transfer.
Firmware Upgrade – AMWX Tuner
The procedures for upgrading the firmware for the AM/WX Tuner are almost
identical to those for the FM Tuner. The difference is that the AMWX Tuner is not a
standalone Cresnet device, but is a sub-slot device of the FM Tuner. To upgrade the
firmware, complete the following steps.
1. Make sure that the AM/WX Tuner is connected to the FM Tuner (refer
to “Hardware Hookup” on page 12) and that “Communication
Settings” that begins on page 34 has been performed.
2. As shown after this step, select File Transfer | Update Sub-Slot
Device Firmware from the Viewport menu.