Cal Flame G3000 - Manual (Page 26)

Barbecue Owner’s Manual
Assembly and Installation
www.calspas.com
Figure 26. Canopy final installation
Awning Installation
All screws used for the installation of the awning are self-tapping sheet metal screws. No drilling is neces-
sary.
1. Line up the holes for the awning bracket with the corresponding pre-drilled holes on the awning. Use
two carriage bolts for the upper two holes and a flat-head Phillips for the single lower hole. Tighten
until snug, but don’t over-tighten (Figure 27A).
2. After mounting the awning bracket, remove the awning from the box. Tilt the awning at a 45˚ angle
and hang the awning onto the awning bracket (Figure 27B).
3. After making sure that the awning is securely hung onto the awning bracket, tilt the awning up to a
45˚ angle and connect the two male electrical leads securely to the two female electrical leads
attached to the awning. When complete, carefully tuck the wires into the hole and gently lower the
awning (Figure 27C).
4. Place set-screws through the awning bracket and awning into the canopy frame. Do not over-tighten
(Figure 27D).
Figure 27. Awning installation
Page 22
12/17/04