Canopy waterfall and barbecue island waterfall, Led lights – Cal Flame G3000 User Manual

Page 43

Advertising
background image

Barbecue Owner’s Manual

www.calspas.com

Canopy Waterfall and Barbecue Island Waterfall

Although the canopy waterfall and the barbecue island waterfall have different appearances and locations,
they operation in the same manner.

Fill the tank with water and make sure the water level is above the submersible pump.

Ensure the pump is connected to 110V GFCI outlet.

Make sure that there is no debris in the filler pan for the waterfall.

Maintain a consistent water level, as dry pumping will burn out the pump motor.

Turn on the waterfall by flipping up the switch to the ON position (Figure 47).

Figure 47

LED Lights

LED lights use an ON/OFF switch to change one show to the next. (See Figure 45.)

Turn OFF and then ON again in one second or less to go to the next show.

Turn OFF and then ON again in four to five seconds to reset to the first show.

Turn OFF for more than six seconds and it stores the last show you selected, returning to that
show the next time it is switched ON.

Note: When the LED lights are powered ON check that all LED lights are synchronized. If not turn the
switch ON and OFF fast several times and then hold the switch OFF for six seconds and then turn ON to
get all the LED lights synchronized.

Slow color wash

Colors transition gracefully from color to color, cycling trough the
color spectrum. Each color cycle takes approximately three minutes.

Fast color wash

Colors transition from color to color, cycling through the color spec-
trum. Each color cycle takes approximately one minute.

Slow Random color

Colors step or jump from one color to the next in random order.
Each color lasts approximately 10-15 seconds

Fast Random color

Colors step or jump from one color to the next in random order.
Each color lasts approximately five seconds.

Page 39

Operating Your Barbecue

12/17/04

Advertising