Cal Flame G3000 - Manual (Page 48)

Barbecue Owner’s Manual
Operating the Cal Flame Entertainment Center
www.calspas.com
(Caption 1)and C2 (Caption 2). C1 displays the full translation of the primary language in your area.
C2 may be used as a source for secondary languages, simplified English, or other translations trans-
mitted in your area. Closed captioning is not available on all channels or at all times. Only specific
programs are encoded with closed captioning information.
4. Press either CHANNEL up or down to select the function. Make sure the highlight bar is SET PIC-
TURE and then press ENTER.
5. Select the item to adjust. For example, to adjust brightness, press CHANNEL up or down buttons to
select BRIGHTNESS and press ENTER.
6. Adjust the level by pressing VOLUME.
7. To adjust other items, repeat all of the above.
NOTE: The menu or display disappears from the screen if you do not press + or - within a few sec-
onds. Whenever a menu or display disappears from the screen, and + or - buttons on the front
of the TV become the volume adjustment buttons. If you want to adjust the picture only, you
can use the remote control by simply pressing the PICTURE SELECT.
Description of Adjustment Items
ITEM ADJUSTMENT
Press VOLUME Down Press VOLUME Up
CONTRAST Decrease picture contrast Increase picture contrast
for soft color for vivid color
BRIGHTNESS Darken the picture Brighten the picture
SHARPNESS Decrease picture sharpness Increase picture sharpness
TINT Decrease Tint Increase Tint
COLOR Decrease color intensity Increase color intensity
To restore the factory settings
Select the item of picture while the main menu is displayed. Then select the item of RESET. All the pic-
ture functions (CONTRAST, BRIGHTNESS, SHARPNESS, TINT, COLOR) will go back to the factory
settings.
• Press either CHANNEL up or down to select the function. Make sure the highlight bar is AUTO
PROGRAM and then press ENTER.
• Press CHANNEL either up or down to select the function. Make sure the highlight bar is ANTENNA
INPUT and then press ENTER.
Remote Infrared Sensor/Repeater
The LCM1502TV incorporates an infrared sensor which relays the signals from the remote control to
allow the LCM1502TV to be controlled simply by pointing its remote control at the remote sensor. This
provides control of the auxiliary equipment such as a Flex vision VCR or DVD Player. The remote
infrared sensor can relay signals from most manufacturers’ remote controls to its respective component
connected to the video 1 and 2 inputs. In this case, you must use the remote control supplied with the
other manufacturer’s component.
Page 44
12/17/04