Kenmore POWER MISER 153.330551 - Manual (Page 20)

Service and Adjustment
Tank (Sediment) Cleaning
Sediment build-up on the tank bottom may create varying
amounts of noise, and if left in the tank will cause premature
tank failure. In some water areas, you may not be able to drain
all sediment deposits by simply draining the tank. In these cases
Mag Erad (part no, 23600) can be used to help remove the sedi­
ment deposits. This may be ordered from the Sears Service
Center. For ordering, refer to the “Parts Order List” section.
Venting System Inspection
At least once a year a visual inspection should be made of the
venting system. You should look for;
• Obsrructions which could cause improper venting. The com­
bustion and ventilation air flow must not be obstructed.
• Damage or deterioration which could cause improper vent­
ing or leakage of combusdon products.
• Rusted flakes around top of water heater.
AWARNING
Chemical vapor corrosion of the flue and vent system may
occur if air for combustion contains certain diemical vapors.
Spray can propellants, deaning solvents, refrigerator and air
conditioner refrigerants, swimming pool chemicals, calcium
and sodium chloride, waxes, bleach, and process chemicals are
typical compounds v^ich are potentially corrosive.
AWARNING
Obstructed or deteriorated vent systems may present a serious
health risk or a^hyxiation.
AWARNING
Be sure the vent piping is properly connected to prevent
escape of dangerous flue gasses which could cause deadly
asph^ation.
AWARNING
if after inspection of the vent system you found sooting or
deterioration, something is wrong. Call the local gas utility to
correct the problem and dean or replace the flue and venting
before resuming operation of the water heater.
Burner Inspection
^____________ AWARNINCT_____________ _
Do not use this appliance if any part of it has been under water.
Immediately call a Sears Service Technician to inspect the
appliance and to replace the gas control or any part of the
burner system which has been under water.
At least once a year a visual inspection should be made of the
main burner and pilot burner. The drawing is for your reference.
You should check for sooting which is not normal and will
impair proper combustion.
AWARNING
Soot build-up indicates a problem that requires correction
before further use. Turn “OFF” gas to water heater and leave
“OFF" until repairs are made, because failure to correct the
cause of the sooting can result in a fire or explosion causing
DEATH,
SERIOUS BODILY INJURY, OR PROPERTY
DAMAGE.
Burner Cleaning
In the event your burner needs cleaning, use the following
instructions;
If inspection of the burner shows that cleaning is required, turn
the gas control knob clockwise (/■ '''"~^) to the “OFF” position,
depressing slightly.
NOTE: The knob cannot be turned £rom “PILOT” to “OFF”
unless knob is depressed slightly. DO NOT FORCE.
Loose deposits on or around the burner can be removed by care­
fully using the hose of a vacuum cleaner inserted through the
access door of the water heater. If the burner needs to be removed
for additional cleaning, call the Sears Service Center to remove
and clean the burner and correct the problem that required the
burner to be cleaned.
20