Kenmore 3405594 - Manual (Page 25)

I. LEVEL LAUNDRY CENTER J. INSTALL GAS LINE
/oT
1/0
w Benefit
Leveling your laundry center
properly prevents excessive
noise and vibration.
STEP 1. Check levelness of the
laundry center by placing a level on
top of the washer, first side-to-side;
then front-to-back.
The proper gas connection ensures
a safe installation that meets local
code requirements.
GAS REQUIREMENTS
A
WARNING
STEP 2. If laundry center is not level,
prop up the front of the laundry center
and adjust the front legs up or down as
necessary. Lower laundry center. Repeat
STEP 2 until the laundry center is level.
U/
Explosion Hazard
Use a new AGA approved gas
supply line.
Connect laundry center to a regulated
gas supply with a shut-off valve.
L.P. gas supply pressure must not
exceed 13" water column.
Securely tighten all gas connections.
Failure to follow these instructions
can resuit in death, explosion, or fire.
It is your responsibility to contact a
qualified gas line installer to ensure
you have natural gas.
• The design of this laundry center has
been certified by the American Gas
Association for use at altitudes up to
2,000 feet above sea level at the B.T.U.
rating indicated on the modei/serial
number plate. Burner input adjustments
are not required when the laundry
center is operated up to this level.
• When installed above 2,000 feet,
a four percent (4%) reduction of the
burner B.T.U. rating shown on the
modei/serial number plate is required
for each 1,000 foot increase in eleva­
tion. For assistance when converting
to other gas types and/or installing
above 2,000 feet elevation contact
your local service company.
25