Kenmore 3405594 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 1. Remove the red cap from
the gas pipe. Move the laundry center
to its final position.
STEP 2. Connect gas supply to laundry
center. Use a wrench to tighten. For
gas connections you must use pipe joint
compound resistant to the action of
L.P. gas. Apply pipe joint compound
to the non-flared male threads only.
There should be a natural loop in the
flexible gas connector. The flexible gas
connector must not be twisted, kinked
or attached with any sharp bends.
CONNECT LAUNDRY CENTER
TO GAS LINE
STEP 3. Open the shut-off valve in the
supply line. The valve is open when the
handle is parallel to the gas pipe.
OPEN
VALVE
STEP 4. Test all the connections by
brushing on a soapy water solution
(liquid detergent also works well).
Bubbles will show a leak. Correct
any leak found. Never test for gas
leaks with a flame.
CORRECT
WRONG
27