Materials needed, Basic tools, Additional tools needed when sweat soldering – Kenmore POWER MISER 153.320661 User Manual
Page 6: Materials and basic tools needed
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
L
Materials Needed
MATERIALS AND BASIC TOOLS NEEDED
J
To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials,
depending on your
type
of
installation.
WATER HEATER INSTALLATION KIT WITH
FLEXIBLE CONNECTORS FOR 3/4” OR 1/2”
THREADED OR COPPER PLUMBING
EXPANSION
TANKS
FOR
THERMAL
EXPANSION CONDITIONS AVAILABLE IN 2
GALLONS , AND S GALLONS CAPACITY
THROUGH
LOCAL
SEARS
STORE
OR
SERVICE CENTER.
DRAIN PANS AVAILABLE IN 20”
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 18” OR LESS,
24”
DIAMETER
FOR
WATER
HEATERS HAVING A DIAMETER 22”
OR LESS AND AVAILABLE IN 28”
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 26” OR LESS.
Basic Tools
You may or may not need all
of these
tools,
depending
on your
type of
installation.
These tools
can
be purchased
at
your local
Sears store.
Pipe Wrench {2)
Screwdriver
6 Foot Tape or Folding Rule
Garden Hose
Drill
Pipe Dope or Teflon Tape
ROLL OF TEFLON TAPE (USE ON
WATER CONNECTIONS)
tü.
PIPE DOPE (SQUEEZE TUBE)
USE FOR WATER CONNECTIONS
SLOT-HEAD SCREWDRIVER
|^^a===
PHILLIPS SCREWDRIVER
GARDEN HOSE
8 FOOT TAPE
PIPE WRENCH
Additional Tools Needed When Sweat
Soldering
Tubing Cutters or Hacksaw
Propane Torch
Soft Solder
Solder Flux
Emery Cloth
Wire Brushes
TUBING CUTTER
HACKSAW
ROLL OF
EMERY CLOTH
ROLL OF
LEAD-FREE
SOFT SOLDER
SOLDER
FLUX
3/4” (19 mm) WIRE BRUSH
PROPANE
TORCH
1/2” (13 mm) WIRE BRUSH