Care ñkd cleanins, Self-cleaning cycle (cent.) – Kenmore 911.94752 User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CARE ñKD CLEANINS

Self-Cleaning Cycle (cent.)

1

.

For best results, follow the steps

in PREPARING YOUR OVEN.

2,

Slide the self-clean lock handle to

the right as far as it will go, Do not
force the handie,.

3. Turn the OVEN CONTROL KNOB

to CLEAN The CLEAN and OVEN
ON indicator lights wiil glow.

If the CLEAN indicator flashes, the

door is not closed completely.,
Simply push the handle to the lock
position-

4. The clean cycle lasts 4 hours

and 20 minutes—this includes a
cool-down time You may change
this to any time from 3 hours to
5 hours and 59 minutes by
touching the HOUR/Ìl/ilN UP and/
or DOWN arrow pads

When the door locks, CLEAN
and OVEN ON indicator lights
will glow. The oven temperature
must drop below the locking
temperature before the door can
be opened. The CLEAN and
OVEN ON Indicators will blink at
the end of the cycle,

5. Turn the OVEN CONTROL KNOB

to the OFF position and unlock
the door

1. Make sure the correct time of day

is displayed

2. For best results, follow the steps

in PREPARING YOUR OVEN

3. Slide the seif-clean lock handle to

the right as far as si will go. Do not
force the handle

4. Turn the OVEN CONTROL KNOB

to CLEAN The CLEAN and OVEN

ON indicator lights will glow

5. To delay the start of the dean

cycle touch the START TIME
nWiflPP nart

6. Touch the HOUR/MIN UP and/or

DOWN arrow pads to set the time

of day you want the oven to start
cleaning

7. When the cycle is finished, the

OVEN ON and CLEAN indicator
lights will flash. Turn the OVEN
CONTROL KNOB to the OFF
position and unlock the door

Turn the OVEN CONTROL KNOB to

the OFF position. Wait (approx, 1 hour)
before attempting to open the door. The
indicator light will not biink if the cycle is
stopped.

After the cycle, you may notice some
white ash in the oven Just wipe it up
with a damp cloth or sponge.

If white spots remain, scrub them with
a soap-filled pad. Be sure to rinse

thoroughly. These are usually deposits
of salt that cannot be removed during
the cycle.

If for any reason you are not satisfied

with the cleaning results. Just repeat
the cycle.

24

Advertising
This manual is related to the following products: