Kenmore 911.94752 - Manual (Page 4)

Anti-Tip Bracket (contd.)
Step 2
Anti-tip bracket installation
A. Wood Construction:
1. Floor: Drill a W pilot hole in
the center of each pre-marked
wood floor hole position (a nail
or awl may be used if a drill is
not available),
AND
2. Wall: Drill an angled Vs“ pilot
hole (as shown in Fig. 2) in
the center of each pre-marked
wall hole position (a nail or awl
may be used if a drill is not
available).
ATTACHMENT TO WALL AND FLOOR
IMPORTANT SAFETY
INSTRUCTIONS
B. Mount the ANTI-TfP bracket
with the 4 screws provided as
illustrated in Fig. 2
C. Concrete Construction:
1. Hardware required;
4 each y/ X 1 Vi lag bolt
4 each Vi 0 D sleeve
anchor
2. Drill the recommended size
hole for the anchors into the
concrete at the center of each
pre-marked concrete floor and
wall hole position. Install the
sleeve anchor into the drilled
holes and then install the lag
bolts through the bracket,
DO NOT OVERTIGHTEN
T
he bolts .
step 3
Checking the installation
A.
B.
Complete the installation of
the range per the instaliation
instructions provided with it.
Check if the ANTt-TiP bracket is
installed and engaged properly
Remove the kick panel or storage
drawer and inspect the REAR
LEVELING LEG. Make sure it fits
securely into the slot See Fig. 1.