Kenmore 911.94752 - Manual (Page 30)

CARE AND CLEANING
Removable Parts (cont)
CLEANING MATERIALS
• Dishwashing detergent
• Warm water
• Scouring pad or soap-filied pad
TO REMOVE
1. Pu!l the racks out to the stop
position.
2. Pull up the front of the rack and
slide under the bump of the rack
guide
TO CLEAN
Clean with warm water and detergent
For hard-to-remove stains, gently
scrub with a scouring pad or a
soap-filled pad Rinse welt.
TO REPLACE
1. Place the raised back of the rack
onto the rack guides.
2. Lift the front of the rack until the
raised back slides under the bump
of the rack guides.
3. Slide the rack all the way back
TO REMOVE
1 .
2.
Fully open the
door.
Push the hinge
locks down
toward the
door frame, to
the unlocked
position.
This may
require a
flat-blade
screwdriver
Lock
(Uniocked
Position)
Slot
Hinge Arm
3. Firmly grasp both
sides of the door
at the top
Close door to
the door
removal position.
Lift door up until
the hinge arm is
clear of the slot.
Removal Position
TO REPLACE
1. Firmly grasp both Bottom
sides of the door if?®
at the top, °
2. With the door at
the same angle
as the removal
position, seat
the indentation
of the hinge arm
into the bottom
edge of the hinge
V* v'
slot.
Hinge
Arm
indentation
continued on next page
30