Kenmore ULTRAFILTER 650 625.38556 - Manual (Page 10)

step 2 - Install RO Drain In Remote Location
Outside Faucet
(Flard Water)
Soft Cold Water
Soft Flot Water '
BLUE Tubing
to Reverse
Osmosis Air
Gap Faucet
Remote Location
Installation
: q :
Airgap
1
-
1
/
2
"
Stand pipe
Sump
1
Q
T
Airgap 1-1/2"
A
Airgap
1
-
1
/
2
"
Laundry Tub
Floor
Drain
Figure 9
Figure 10
INSTALL A REMOTE DRAIN POINT AND AIR GAP
(Remote Location)
You can also run the drain tubing to an existing drain in
the house. A floor drain, laundry tub, standpipe, sump,
etc. are suitable drain points. See Figure 10. This type of
drain is the preferred over the p- trap drain adapter.
Check your local codes. Longer lengths of tubing (see
parts list in back of manual) may be needed.
Always be sure to provide an air gap between the end of
the hose and the drain point. This will prevent water
from backing up into the system. Airgaps are required
code in most areas.
To install a remote drain point, complete the following
steps:
1. Locate the 1/4" red tubing on the Reverse Osmosis fil­
ter assembly. See Figure 9.
2. Determine if this length is long enough to reach the
drain point.
3. If not, disconnect the 1/4" red tubing and replace with
an adequate length of tubing to reach the drain point.
Refer to Step 6 later in the manual on how to discon­
nect and connect tubing.
NOTE; A flow control insert is located in the red
tube. Refer to Key No. 14 on Page 26. This insert
must be saved and placed in the new length of tub-
ingi
4. Run the tubing to the drain point and secure at the
end with a bracket (purchased locally). See Figure 10.
Provide a 1-1/2" air gap between the end of the tube
and the drain. See Figure 10.
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
10