Install reverse osmosis eieter assembey, Step 4 - install storage tank, Instale storage tank – Kenmore ULTRAFILTER 650 625.38556 User Manual
Page 11: Step 3 - instali ro filter assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
step 3 - Instali RO Filter Assembly
INSTALL REVERSE OSMOSIS EIETER
ASSEMBEY
The Reverse Osmosis Filter Assembly can sit upright or
lay on it's side. When planning your installation, you
need to allow adequate tubing lengths to be able to
access the back of the Reverse Osmosis assembly in
order to change the monitor battery. See Figure 11.
Step 4 - Install Storage Tank
INSTALE STORAGE TANK
1. Apply thread sealing tape to the threads on the nipple
at the top of the tank (max. 2 wraps). See Figure 12.
2. Locate the tubing connector. Tighten the tubing con
nector with a wrench onto the tank nipple 7-8 turns,
being careful not to cross thread or overtighten. See
Figure 12
3. Do not connect the tube at this time. This will occur
later in the assembly.
4. Place the storage tank next to the Reverse Osmosis
Assembly. The tank can be placed upright or on its
side.
tubing connector
tank nipple^
storage tank
Figure 12
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
11