Kenmore 16238 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
32. Attach the two wires from the cross lighter
and the two wires from the side burner
to any of the four small terminals on
ignitor module as shown.
Next, Attach the two wires from console
assembly to the two large terminals on ignitor
module as shown.
Ignitor Module
Terminals
34. Snap ignitor module tabs into
holes on back left side of front
panel as shown.
NOTE: Do not remove ignitor module
once installed. The plastic mounting tabs
on the ignitor “hook” into the mounting
holes and are not designed to be repeatedly
removed and re-installed Replace battery
in module with module in place..
23
Advertising