Assembly, Assembly -24 – Kenmore 16238 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
ASSEMBLY
1. Turn leg assembly upside down as
shown and insert caster plug.
Make sure caster plug tab is in line with
notch in leg. {SEE FIG “A”)
2. Turn leg assembly over and tap on a hard surface
until the caster plugs are fully seated.
Non-Locking Caster
3. Insert locking casters into the caster plugs on front of leg
assemblies and press in until caster is fully seated as shown.
Insert caster into holes on outside
corner of caster plug as shown.
Leg Assembly
(Left Hand shown)
Console mounting
tabs are on front
side of leg
assemblies.
4. Insert non-locking casters into the caster plugs
on rear of leg assemblies.
Advertising