Lighting insiryctions, Surface burner controls, To light a surface burner – Kenmore 73511 User Manual

Page 21: How to select flame size, Top“of“range cookware, Surface cooking

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Surface Cooking

Lighting Insiryctions

Surface burners on this range are lighted by electric
ignition, ending the need for standing pilots with con­
stantly burning flames.,

In case of a

power outage, you can light the pilotless

ignition surface burners on your range with a m atch.
Hold a lighted match to the burner, then turn the knob

to the LITE position.

Use extreme caution when

lighting burners in this manner.

Surface burners in use when an electrical power fail­
ure occurs will continue to operate normally.

Surface Burner Controls

The knobs that turn the surface burners on and off are
located on the control panel in front of the burners.

The two knobs on the left control the left front and left

rear burners. The two knobs on the right control the
right front and right rear burners.

To Light a Surface Burner

Push the control knob in

and turn it to LITE You
will hear a little clicking

nois6“the sound of the
electric spark igniting the
burner.

Fiame wit! be alm ost horizontal and will lift slightly

away from the burner when the burner is first
turned on. A blowing or hissing sound m ay be

heard for 30 to 60 seconds. This normal sound is

due to im proved injection of gas and air into the burner.

Put a pan on the burner before iighiing it, or adjust the

flam e to m atch pan size as soon as it lights, and the

blowing or hissing sound will be m uch less noticeable

Note:

e Do not

Operate a burner for extended periods of time

without having cookware on the grate. The finish on
the grate m ay chip without cookware to absorb the

heat

0

Check to be sure the burner you turned on Is the one

you want to use.

0

Be sure the burners and grates are cool before you

place your hand, a pot holder, cleaning cloths or other
m aterials on them

How to Select Flame Size

W atch the flam e, not the knob, as you reduce heat
The flam e size on a gas burner should match the
cookware you are using.

NEVER LET THE FLAM E
EXTEND UP THE SIDES
OF

THE

COOKW ARE.

Any flam e larger than the

bottom of the cookware is
wasted and only serves
to heat the handle.

When using aluminum or aluminum-clad stainless
steel pots and pans,

adjust the flam e so the circle it

m akes is about 1/2 inch sm aller than the cookware’s
bottom.

W hen boiling, use this sam e fiam e size— 1/2 inch

sm aller than the bottom of the cookware— no m atter

what the cookware is m ade of. Foods cook just as

quickly at a gentle boil as they do at a furious, rolling
boil. A high boil creates steam and cooks away m ois­
ture, flavor and nutrition. Avoid it except for the few
cooking processes that need a vigorous boil.

When frying or warming foods in stainless steel,
cast iron

Of

enamelware,

keep the flam e down— to

about 1/2 the diam eter of the pan.

When frying in glass or ceramic cookware,

lower

the flame even m ore.

Top“Of“Range Cookware

Aluminum:

M edium-weight cookware is recom mend­

ed because it heats quickly and evenly. Most foods
brown evenly in an alum inum skiilei. M inerals In food
and water will stain but will not harm aluminum . A
quick scour with a soap-filled steel wool pad after
each use keeps alum inum cookware looking shiny
and new. Use saucepans with tight-fitting lids for cook­

ing with minim um amounts of water,

Cast Iron:

if heated slowly, most skillets will give sat­

isfactory results.

Enamelware:

Under some conditions, the enam el of

som e cookware m ay melt, Follow cookware manu­
facturer's recomm endations for cooking methods.

Glass:

There are two types of glass cookware—

those for oven use only and those for top-ot-range

cooking (saucepans, coffee and teapots),, Glass con­
ducts heat very slowly

Heatproof Glass Ceramic:

Can be used for either

surface or oven cooking. It conducts heat very slowly
and cools very slowly. Check cookware manufacturer’s
directions to be sure it can be used on gas ranges

Stainless Steel:

This m etal alone has poor heating

properties and is usually combined with copper,
aluminum or other m etals for im proved heat distri­
bution

Com bination

m etal

skillets

generally

work

satisfactorily if used at m edium heat as the m anu-

20

Advertising
This manual is related to the following products: