Before a self-cleaning cycle, How to set oven for cleaning, Operating the self“c!eaning oven – Kenmore 73511 User Manual

Page 30: Step 3, Clean

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Operating the Self“C!eaning Oven

Before a Self-Cleaning Cycle

Step 1: Remove the broiler pan, broiler rack, all cook­
ware and any alum inum foil from the oven— they can’t
withstand

the

high

cleaning

tem peratures

(Oven

shelves may be left in oven. Note: Shelves will discol­
or during the self-cleaning cycle.)

Step 2: W ipe up heavy soli on the oven bottom

A. Oven Front Fram e

B. Oven Door Gasket

C. Oven Light

Step 3: W ith a dampened cloth, clean spatters or
spills on oven front frame (A) and only that area on
the oven door that is outside the gasket (B). Do not
clean the gasket, Polish cleaned areas with a dry
cloth Never use a com mercial oven cleaner in or

around the self-cleaning oven.

Step 4: Close the door and make sure the oven light

(C) is off

Oven shelves m ay be cleaned in the self-cleaning
oven. However, they will darken, lose their luster and
become hard to slide. To make shelves slide m ore
easily, after each self-cleaning cycle, dam pen fingers
with a sm all amount of cooking oil and rub lightly over
edges of shelf that contact shelf supports.

If your range is equipped with porcelain enam el drip
pans, you can clean them in the seif-cleaning oven
After wiping off any boilovers that are not stuck on,
place one pan upside down on each oven shelf.

Caution:

Chrom e

drip

pans

{on

models

so

equipped) should never be cleaned in the self­
cleaning oven.

Do not use com mercial oven cleaners or oven protec­

tors in or near the self-cleaning oven., A com bination
of any of these products plus the high clean cycle
temperatures may damage the porcelain finish of the

oven.

Important:

The

oven

door

m ust

be

dosed

and

latched and all controls m ust be set correctly for the
self-cleaning cycle to work properiy.

How to Set Oven for Cleaning

step 1: Follow steps at left to prepare the oven for
cleaning.

Step 2: Close the oven
door and slide latch han­
dle to the right as far as it
will go.

step 3:

Touch

CLEAN

pad. "---------------- ”

appears in display and "CLEAN TIM E”
flashes.

Step 4: Touch INCREASE pad. Four

hours is autom atically programm ed for
Clean Time.

Step 5: Press & hold or tap INCREASE or DE­
CREASE pad until desired Clean Tim e is displayed,
(Tap to change time 5 m inutes a tap. Press

&

hoici to

change time 10 m inutes at a tim e.)

Clean Time for heavy soil is norm ally 4 hours. You can
change the Clean Tim e to anywhere between 2 and 4

hours, depending on how dirty the oven is.

The self-cleaning cycle will autom atically begin within

a few seconds and the word “ON" will appear on the
display.. W hen the oven heats to a high temperature,
the word "LOCK" will be displayed and, a short time
later, the door latch handle will be locked in position It
wi!l not be possible to open the oven door until the
temperature drops below the lock tem perature

W hen the clean cycle is finished, the word “CLEAN”
will go out in the display and the oven will begin to
cool W hen the oven tem perature has fallen below the

locking tem perature (about 20-30 m inutes alter the
word “CLEAN” goes out at the end of the clean cycle),
the word “LOCK" goes out and the door can be
opened.

Step 6: W hen the LOCK light is off, slide latch handle
to the left as far as it will go and open the door,

Never force the latch handle. W ait until the word
“LOCK” goes out in the display. Forcing the
handle m ay dam age the door

lock.

(continued next page)

pq

Advertising
This manual is related to the following products: