Kenmore 73511 - Manual (Page 8)

Usage Situations Where Appiiance Power Cord
Will Be Disconnected FREQUENTLY:
Do not use an adapter plug in these situations
because disconnecting of the power cord places
undue strain on the adapter and leads to eventual fail­
ure of the adapter ground term inal. The custom er
should have the two-prong wall receptacle replaced
with a three-prong (grounding) receptacle by a quali­
fied electrician before using the appliance.,
The installation of appliances designed for m obile
hom e installation m ust conform with the M anufactured
Home Construction and Safety Standard, Title 24
CFR, Part 3280 (form erly the Federal Standard for
M obile Hom e Construction and Safety, Title 24. HUD,
Part 280) op when such standard is not applicable,
the Standard for Manufactured Hom e Installations, lat­
est edition (Manufactured Hom e Sites, Comm unities
and Set-Ups), ANSI A225.1, latest edition, or with
local codes
Electrical Disconnect
1. Locate disconnect
plug at left rear of
burner box on the
range back.
2, Pinch sides of con­
nector and pull out of
range back.
Step 4
Seal the Openings
Seal any openings in the wall behind the range and in
the floor under the range when hookups are com pleted.
Quality of Flames;
The com bustion quality of burner flam es needs to be
determined visually.
Step
S
Check Ignition of Surface Burners
Operation of all cooktop and oven burners should be
checked after range and gas supply lines have been
carefuify checked for leaks
Push in one of the surface burner controls and turn it
to the LITE position. You will hear a snapping sound
indicating proper operation of the spark m odule. Once
the air has been purged from the supply lines, burners
should light within 4 seconds. After burner lights,
rotate knob out of the LITE position. Try each burner
in succession until all burners have been checked.
( A ) Yellow fiames-
Cal! for service
(B) Yellow tips on
Norm al for LP gas
(C) Soft blue flames—
Norm al for natural gas
* If burner flames look like (A), cal) for service. Normal
burner flam es should look like (B) or (C), depending
on the type of gas you use.
* W ith LP gas, some yellow tipping on outer cones is
norm al.
Check ignition of Oven Burner
Your oven is designed to operate quietly and autom ati­
cally. To operate the oven, touch BAKE pad and then
touch INCREASE pad until "350*” appears In the dis­
play, After 30-60 seconds, the oven burner will ignite
and burn until the set tem perature is reached, The oven
burner will continue to cycle on and off as necessary to
m aintain the oven at the tem perature indicated by the
display.
The oven requires eiectrlcal power to operate. The
oven cannot be lit during a power outage. Gas will not
flow unless the glow bar is hot
if the oven is In use when a power outage occurs, the
oven burner will shut off and cannot be re-lit until
power is restored