Kenmore 73511 - Manual (Page 41)

The Problem Solver
(continued)
PROBLEM POSSiBLE CAUSE AND/OR W HAT TO DO
SURFACE LIGHT
DOES NOT W ORK »Fluorescent lam p is loose or defective. Adjust or replace.
«Switch operating fight is broken. Call for service.
STRONG ODOR »Improper air/gas ratio in oven Adjust oven burner air shutters.
® An odor from the insulation around the oven liner is norm a! for the first few
tim es oven is used. This is temporary.
OVEN W ILL NOT
SELF-CLEAN " Oven tem perature is too high to set seif-cleaning operation. Allow the range to
cool to room temperature and reset the controls.
® Door latch handle not moved all the way to the right.
OVEN DOOR W ILL
NOT UNLOCK * Oven must coo! below locking tem perature (approximately 30 m inutes after the
w IC7 q . i I wywiC?
lO
wwH
i j O * '
OVEN NOT CLEAN
AFTER CLEAN
CYCLE ® Oven controls not set properly. Review pages 29 and 31.
* Heavily soiled ovens reguire 3!A to 4-hour Clean Tim e.
® Heavy spillovers should be cleaned up before starting clean cycle.
“door” APPEARS
ON DISPLAY e Self-cleaning cycle has been selected but latch handle was not m oved all the
way to the right. M ove latch handle.
® Latch handle was m oved to the right but another program other than seif­
cleaning was selected. Move latch handle to the right only when setting self-
cieaning cycle.
CONTROL BEEPS
AFTER ENTERING
OVEN TIM E OR
STOP TIME
«This is rem inding you to enter a bake temperature. (See Steps 7 and 8 on
page 23)
“F-" AND A NUM BER
FLASH ON DISPLAY ® This is the function error code, if function error code appears during the seif­
cleaning function, check oven door latch— the latch handle may have been
m oved, even if only slightly, from the latched position. M ake sure latch is moved
to the right as far as it will go. Touch CLEAR/OFF pad. If function error code
does not clear, unplug the range and then plug it back in. If function error still
appears, unplug the range and cali for service.
40