Kenmore 73511 - Manual (Page 35)

Care and Cleaning
(continued)
Oven Lamp Replacement
CAUTION; Before replacing your oven bulbj dis­
connect electrical power to the range at the main
fuse or circuit breaker panel. Be sure to let the
lamp cover and bulb coo! completely.
The oven lam p (bulb) is
covered with a rem ovable
glass cover that Is held in
place with a bail-shaped
wire. Rem ove oven door,
if desired, to reach cover
easily.
To remove:
1, Hold hand under cover so it doesn't fall when
reteased, W ith fingers of sam e hand, firmly push back
wire ball until it clears cover. Lift off cover. DO NOT
REMOVE ANY SCREW S TO REMOVE COVER.
2. Replace bulb with a 40-watt household appliance
bulb.
To replace cover:
1. Place it into groove of lamp receptacle. Pull wire bail
forward to center of cover until it snaps into place.
W hen in place, wire holds cover firmly. Be certain wire
baii is in depression in center of cover
2. Connect electrical power to the range
Surface Light and Starter
(On m odels so equipped)
CAUTION: Do not touch the bulb with wet hands
or when bulb Is hot. Never wipe the light area with
a wet cloth. Electrical power must be shut off if
you have to replace a buib.
To replace bulb:
1. Flip front of the hinged
canopy up
2. Remove fluorescent
light bulb. Replace the
bulb with one of the sam e
length and wattage.
3. Lower the canopy.
To replace starter:
1. Open canopy and rem ove bulb as explained above,
2. Grasp starter, turn it counterclockwise about one-
quarter turn and lift out Replace with one of the sam e
wattage.
3. Reposition bulb and lower the canopy
34