Kenmore OASIS HT W10026626B - Manual (Page 9)

NOTE: Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
4. Using pliers, tighten the coupling with an additional
two-thirds turn.
3. Fasten the drain hose to the laundry tub leg or drain
standpipe with the beaded tie strap. See view A or B.
5. Attach the cold water hose to the inlet valve labeled cold.
6 . Screw on coupling by hand until it is seated on the washer.
7. Using pliers, tighten the coupling with an additional two-
thirds turn.
NOTE: Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
Check for leaks
■ Turn on the water faucets and check for leaks. A small
amount of water might enter the washer. You will drain this in
a later step.
NOTE: Replace inlet hoses after 5 years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates for future reference.
■ If you connect only one water hose, you must cap off the
remaining water inlet port.
■ Periodically inspect and replace hoses if bulges, kinks,
cuts, wear, or leaks are found.
1. Drape the power cord over the console.
2. Remove any cardboard used to move washer.
A B C
If the washer faucets and the drain standpipe are recessed,
put the formed end of the drain hose into the standpipe.
Tightly wrap the tie strap around the water inlet hoses and the
drain hose. See view C.
^WARNING
Excessive Weight Hazard
Use two or more peopie to move and instaii washer.
Faiiure to do so can result in back or other injury.
One washer foot has been installed at a different height on your
new washer. The other three feet were preset at the factory.
Properly leveling your washer will minimize noise and vibration.
1. Slide the washer to its final location.
2. Push on upper front panel to be sure the washer is on its rear
feet.
3. Lower right front foot until it contacts the floor. By hand, firmly
rotate foot as much as an additional 1 V 2 turns. The other three
feet have been preset at the factory.