Connecting machine to power supply, Before using your sewing machine, For your safety – Kenmore 385.19005 User Manual
Page 9: Polarized plug
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 11. GETTING READY TO SEW
Connecting Machine to Power Supply
(T) Power supply plug
(g) Power switch
(I) Outlet
© Foot control
(5) Foot control plug
(f) Machine plug
(7) Machine sockets
1 T u r n off the power switch Insert the foot control plug
(f) and machine plug (§) into the machine sockets (|)
2, Insert the power supply plug (© into the outlet (|,)
3. Tur n the power switch (I) to turn on the power and
the sewing light.
Note:
»if you turn off the power switch, wait 5 seconds before
turning it on again
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the ptesser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
«When leaving the machine unattended,
«When attaching or removing any parts,,
«When cleaning the machine,
* Do not place anything on the foot control, when not
sewing.
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way If the plug
does not fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet
Do not modify the plug in any way.