Troubleshooting, High temperature shut off system, Cont’d) – Kenmore POWER MISER 153.32154 User Manual
Page 23: Not enough or no hot water, Water is too hot, Troubleshooting (cont*d)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
(cont*d)
HIGH TEMPERATURE SHUT OFF SYSTEM
(cont’d)
• Remove the two screws securmg the access panel and remove
panel,
• Remove the insulation block and. pad,
• Reset the high limit by pushing in the red button marked
“RESET”.
■
-RESET BUTTON
• Replace the insulation block and, pad so that it com'
covers the thermostat and element.
• Replace the access panel,
• Turn “ON” electric power to the water heater.
A CAUTION
If the high limit must be reset again, call Sears Service
Department to find out why the high limit turned “OFF”
the electric power.
NOT ENOUGH OR NO HOT WATER
•
In a new installation, the water heater may not be properly
connected. Make sure the cold water supply valve is open.
Review and, check piping installation. Make sure that the
cold water line is connected to the cold water inlet to the
water heater and. the hot water line to the hot water outlet
on the water heater.
•
Make sure the electrical supply to your water heater is
“ON”,
■
■
•
Cheek for loose or blown fuses in your water heater circuit.
Circuit breakers weaken with age and may not handle their
rated load, and. should be replaced,.
•
Make certain the disconnect switch, if used, is in the “ON”
position,
•
Cheek to see the electric service to your house has not been
interrupted. If this is the ease, contact the electric company,
•
Arc the thermostats set to the desired temperature? See
“Temperature Regulation” section,
•
If you had experienced very hot water and now no hot
water, the problem may be due to the high temperature
shut off system. See “High Temperature Shut Off’ System”
in the “Troubleshooting” section.
•
During very cold, weather, the incoming water will also be
colder and, it will require a longer time to become heated.
•
The hot water usage may exceed the capacity of the water
heater. If so, wait for water heater to recover after abnormal
demand,. .Also examine pipes and faucet’s for possible water
leaks,
•
rf you can not determine the problem, then call the Scars
Service Department.
WATER IS TOO HOT
Adjust the thermostat to a lower setting. See the “Temperature
Regulation” section.