Kenmore 385.15208 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
' Inserting bobbin
Q] Place a bobbin in the bobbin case, making sure the
thread feeds clockwise from the bobbin.
[11
Draw the thread through the slot of the case.
[|] Continue to draw the thread under the tension spring (|)
and through the opening..
Pull out about 4” (10 cm) of thread.
0 Tension spring
0 Holding the latch open, position the bobbin case into the
shuttle, and then release the latch.
[|]The case should lock into the place when the latch is
released.
22
Advertising