Kenmore 110. 2404# - Manual (Page 10)

8 . If the washer is not level, move the washer out slightly, tip
back, prop up the front of the washer with the wood block
and adjust the feet up or down as necessary. Repeat Steps
5 through 8 until washer is level.
9. After the washer is in the final location and level, use a ®/i6 in.
(14 mm) open-end wrench to turn the nuts on the feet tightly
against the washer cabinet,
IMPORTANT: If the nuts are not tight against the washer
cabinet, the washer may vibrate.
1.
2 .
3.
4.
5.
6.
7.
Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See “Electrical Requirements.”
Check to be sure all parts are now installed. If there is an
extra part, go back through the steps to see which step was
skipped.
Check to be sure you have all of your tools.
Check to be sure that the yellow shipping strap was removed
from the back of the washer and used to secure the drain
hose.
Dispose/recycle all packaging materials.
Check to be sure the water faucets are on.
Check for leaks around faucets and inlet hoses.
AWARNING
>1
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
8 . Plug into a grounded 3 prong outlet.
9. Remove the protective film on the console and any tape
remaining on the washer.
10. Read “Washer Use.”
11. To test your washer, measure V 2 of the normal recommended
amount of powdered or liquid detergent and pour it into the
washer basket or detergent dispenser (on some models).
Close the lid. Select any cycle, and then pull cycle control
knob to start the machine. Allow it to complete one whole
cycle.
FEATURES AND
BENEFITS
Your new washer has many special features that contribute to
proper cleaning and fabric care. Here are descriptions of the
features and their benefits;
The CATALYST® Cleaning Action
To provide improved stain and soil removal, CATALYST* uses
your detergent in a unique way. Water flushes through the
dispenser to dissolve the detergent. Then the detergent mixture
is sprayed onto the load while the washer spins at low speed.
This cleaning action will last 1 to 5 minutes depending on the
cycle selected. The washer then stops spinning and fills to the
selected water level and continues washing with the selected
cycle. The CATALYST® Cleaning Action is available in the Ultra
Clean and the Whitest Whites cycles. Select any Speed Control
setting, but for best results, select Heavy Duty.
TOTAL CARE™ Agitator
The TOTAL CARE^'^ Agitator moves in three directions to ensure
proper cleaning. At the bottom of your washer the agitator vanes
move back and forth to flex the fabric, loosening the soil. The
upper portion of the agitator has vanes that push the clothes
down in a spiraling pattern to the area of best cleaning action. A
“rollover” motion displaces the clothes already at the bottom. For
your largest loads, the TOTAL CARE'^“ Agitator responds with a
vertical motion that senses the “large load” and guides items to
the bottom.
KING SIZE™ Capacity
Your washer can handle full-sized loads of heavy work clothes,
towels, or mixed items; see “Loading.” Loads with only a few
items can have a lower water setting and need less wash time.
TRIPLE SMART’^'^ Dispensers
The TRIPLE SMART™ dispensers make your washer truly
automatic. It is unnecessary for you to return to the washer
during the cycle to add detergent, bleach, or fabric softener.
Laundry products are diluted with fresh water and added to the
load at the proper time in the wash cycle.
QUIET PAK™ III System
The QUIET PAK™ III System is designed to reduce water sounds
and ringing noises. The cabinet is insulated with sound-damping
materials. A sound-absorbing blanket under the motor and
gearcase also helps to insulate the washer to reduce vibration
noise.
Water Level and Temperature
A Water Level control gives you the flexibility to save water when
washing small loads. The Water Temperature control knob lets
you select a wash and rinse water temperature setting based on
the type of load you are washing. The settings for Automatic
Temperature Control (АТС) take away the worry of undissolved
detergent and ensure consistent cleaning results from season to
season with warm and cold washes.
Wash/Spin Speeds
Six combinations of speeds are provided for wash action (of
agitator) and spin motion (of basket). A Speeds selector control
knob lets you select a wash/spin speed for different types of
fabrics and soil levels.
10