Cannondale S440 - Manual (Page 82)

© 2002 Cannondale Corporation - All Rights Reserved
82
2003 Motorcycle OM.fm
WARNING Indicates a potential hazard that could result in serious injury or death.
nicks, dent).
6. After inspecting the fork legs, apply a small
amount of Ohlins #148-01 grease to the inner
tube.
Bleeding air pressure
NOTE :
Air pressure can build inside the forks through the
up and down action of the forks during a moto, or
through changes in elevation (atmospheric
pressure) during a ride. Release the air pressure
in the fork legs. This pressure will affect the fork
action making the fork legs stiffer or softer. Make
sure the air pressure is bled regularly.
1. Place the vehicle on a stand with the front wheel
off the ground and forks fully extended.
CAUTION :
Clean the area surrounding the screw to
prevent oil contamination. The smallest amount
of dirt can severely damage the forks.
2. Remove the bleed screw located at the top of the
fork leg and allow any accumulated air to
escape.
3. Inspect the bleed screw O-ring for damage. If
damage is found, replace it.
4. Reinstall the bleed screw. Do not over tighten the
screw.
CAUTION :
Do not over-tighten.
Professional Service (Every 25 hours)
We recommend that the fork legs on your vehicle
undergo a comprehensive service program every 25
hours. At this interval, the oil should be changed and
all internal and external components should be
inspected and replaced new if required.
Do not attempt this service yourself. Contact an
authorized Cannondale Motorsports dealer.
1. Bleed screw
(1)