Switch housing installation (continued) – Casablanca Fan Company Casablanca fan c12d4301 User Manual

Page 10

Advertising
background image

10

install the Switch Housing Mounting Screws
Step 13a. locate the two dummy switch housing screws

you removed in Step 8. install them onto the motor as

shown, leaving approximately 1/8” of the threads exposed

for installation of the switch housing.

SwitcH HouSinG inStaLLation (continued)

Step 13b. Connect the plug connector from the motor to

the plug connector from the switch housing assembly.

iMPoRtant:
if you are installing an optional light fixture at this

time, proceed to Step 6 of oPtional liGHt

fiXtuRE inStallation on page 11 now.

Caution:
Both plug connectors are polarized and will only

fit together one way. Make sure the connectors are

properly aligned before connecting them. incorrect

connections could cause improper operation and

damage to the product.

Step 13c. line up the two keyholes in the switch housing

cup with the two screws installed in Step 13a.
Step 13d. Rotate the cup so that the screws are aligned

with the smaller side of the keyholes. tighten the screws

securely by hand only.

install the Switch Housing Cap

notE: Before re-installing the cap, the gasket must be

put on the cap so that the larger gasket holes go over the

alignment pins.

Step 14. line up the two guide pins in the cap with the

two alignment holes of the switch housing. NOTE: The

alignment holes are the larger, non-threaded holes in the

raised rim of the switch housing. Press the cap onto the

switch housing to seat the guide pins into the alignment

holes of the switch housing.
Step 15. Re-install the two screws removed in Step 12 to

tighten the switch housing cap and switch housing.
Step 16. attach a fandangle to each of the pull chains using

the breakaway connectors.

Guide pin

Advertising