Casablanca Fan Company Casablanca fan c12d4301 - Manual (Page 9)

9
C
ottage
™ W
et
Blade BadGe and Blade holdeR InSTallaTIon
Caution:
Blade screws must be tightened securely before
operating the fan.
SwitcH HouSinG inStaLLation
Step 11a. Carefully tilt the blade holder between the switch
housing motor plate and the motor, as shown.
tiP: Rotate the motor beneath the switch housing plate
to attach the blade/blade holder assembly.
Step 11b. using the screws from Screw Pack d, the screws
removed in Step 9, and the screwdriver provided, attach
the blade/blade holder assembly to the motor. tighten
securely by hand only.
Step 11c. after all blade holders are installed, install the
gasket into the switch housing mounting plate. The smooth
side of the gasket should face the fan motor.
tiP: for balancing purposes, loosely install all five blades
to the motor before tightening the blade screws securely.
Preparation
Step 12. locate the switch housing cap assembly and
remove the two 8-32 x 3/8” screws holding the cap onto
the switch housing. Remove the cap and gasket.
notE: Save the two screws — they will be used in Step
15.
Caution:
Handle the gasket carefully to avoid tearing.
Switch hous-
ing Gasket