Casablanca Fan Company Casablanca fan c12d4301 - Manual (Page 6)

6
canopY InSTallaTIon
Step 4. attach the canopy to the crossbar mounting bracket
with three of the 8-32 x 2 1 /
2
” long canopy screws (Screw
Pack B) and lock washers provided with your Casablanca
fan. tighten using the provided screwdriver until snug
against the ceiling.
notE: on sloped ceilings, align the canopy opening with
the top or peak of the room.
canoPy Hardware (not to scale)
canopy
canopy hatch
Screw pack B:
canopy Screws and
washers (5)
Feed outlet box
wires through
canopy opening
hanGInG The Fan
Step 5a. to hang the motor housing assembly in the canopy,
hold the motor housing assembly firmly and insert the ball
into the canopy opening. Check that no wires are pinched.
Rotate the motor housing assembly until the slot in the ball
fits into the pin opposite the canopy opening.
Step 5b. trim excess motor wires, leaving at least 6 inches
above the downrod. Strip 1 /
2
-inch insulation from the end
of each wire using a wire stripper (available at your local
hardware store).
Ball
Slot
pin
canopy Gasket, hang-
ing plate, & crossbar
Mounting Bracket
Installed
canopy
canopy lock
washers
canopy
Screws