Ottage, Getting started, Ceiling hardware – Casablanca Fan Company Casablanca fan c12d4301 User Manual

Page 5: Canopy gasket preparation, Crossbar mounting bracket installation

Advertising
background image

5

C

ottage

W

et

ceiLinG Hardware (not to scale)

using Existing Ceiling fixture outlet Box
after turning the power off at its source (either the circuit

breaker or fuse box), lower the old fixture and disconnect

the wiring. Check the ceiling fixture outlet box to be sure

it is marked “Approved for Ceiling Fan Mounting.” If it is

not, a new box must be installed.

GeTTInG STaRTed

installing a new Ceiling fixture outlet Box
if you do not have an existing fixture located where you wish

to place your Casablanca fan, an approved ceiling fixture

outlet box must be installed and wired.

NOTE: The weight of this fan is 18 pounds.

ceiLinG Hardware

crossbar Mounting Bracket

Screw pack a:

2 1/4” x 8-32 roundhead Screw and washer (2)

1” x 8-32 roundhead Screw and washer (2)

wire nut (4)

WARNING!
to reduce the risk of fire, electrical shock, or

personal injury, mount to outlet box marked

“acceptable fan Support of 22.7 kg (50 lbs.) or

less” using the mounting hardware provided with

the outlet box.

canopy Gasket

hanging plate

canoPy GaSket PreParation

Step 2. fit the hanging plate into the canopy gasket as

shown. Make sure that the four holes of the hanging

plate align with the four indentations on the inside of

the gasket.

canopy

Gasket

hanging

plate

Mounting

Bracket

Screw hole

Proceed with installation as follows:
Step 3. Route the wires from the ceiling outlet box through

the center hole of the canopy gasket and hanging plate and

then the crossbar mounting bracket center hole.
Push the mounting hardware included with the outlet

box through the rubber canopy gasket so that the screws

align with the threaded holes of the ceiling fan approved

outlet box.
using the screwdriver, tighten the screws firmly by hand

only, being careful not to bend the bracket by over-

tightening.

croSSbar mountinG bracket inStaLLation

Caution:
to reduce the risk of personal injury, use only the

mounting hardware provided with the approved

outlet box to install the crossbar mounting

bracket.

ceiling Fan

approved

outlet Box

ceiling wir-

ing

Ridge

Side

down

Green

Ground wire

Flat washer

crossbar

Mounting

Bracket

canopy

Gasket &

hanging

plate

outlet Box

Mounting

hardware

Advertising