Casablanca Fan Company Casablanca fan c12d4301 - Manual (Page 2)

2
circuit Breaker
(Trip breaker for the
circuit you will be
working on)
Fuse Box
(Remove fuse for the
circuit you will be
working on)
84”
SaFe uSe
For best performance and for your warranty to be valid,
use only genuine Casablanca blades, light fixtures, and accessories.
InTRoducTIon
• The blades in each pack are matched for equal weight
to assure smooth fan operation. if more than one fan is
being installed, be careful not to mix blades from different
cartons.
• Inspect the contents of your carton for possible shipping
or handling damage. if parts are missing or damaged, call
1-888-227-2178.
• It is always a good idea to have an assistant to help with
the installation.
• When cleaning, painting, or working near your fan, be
very careful of the fan and blades. always turn the power
off to the ceiling fan before working on it or replacing
lightbulbs.
• Never insert anything into the path of the fan blades while
the fan is in operation.
• Never install a fan over a pool or spa.
• Never operate a fan that has been damaged in any
way. Contact Casablanca fan Company by calling
1-888-227-2178, or contact your local authorized
Casablanca dealer for assistance in obtaining service.
BeFoRe You STaRT
• CAUTION: RISK OF ELECTRICAL SHOCK! installation is to be in accordance with the national Electrical Code,
anSi/nfPa 70-1999, and local codes. all wiring must be performed in accordance with national and local electrical
codes. if you are unfamiliar with the wiring codes, you should use a qualified electrician. to avoid overheating and possible
damage to other equipment, do not install control to a receptacle, fluorescent light fixture, motor operated appliance, or
transformer-supplied appliance.
• This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan
installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling
installations.
• This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit. The maximum
current requirement for the fan with light fixture is 3 amps. The fan uses about 1 amp or 100 watts. Maximum light current
is about 2 amps or 240 watts of lighting.
• Where wire nuts are employed, be sure all bare wires are within the connectors. When installing the canopy hatch, make
sure all wires are within the canopy and that no wires are being pinched.
• WARNING: Do not bend the blade brackets when installing the brackets, balancing the blades or cleaning the fan. Do not
insert foreign objects in between the rotating fan blades.
• WaRninG: to reduce the risk of fire or electric shock, do not use this fan with any solid state speed control device. use
only the control provided with or recommended for this fan.
unpacking
Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts
listed in the parts guide. Before discarding packaging material, be certain that all parts have been removed.
from bottom
edge of blade
to floor
18”
from tip of
blade to wall