Casablanca Fan Company Casablanca fan c12d4301 - Manual (Page 11)

11
C
ottage
™ W
et
3-SPeed • oPeration
Pull-chain switches on the fan control the fan and blade
rotation.
using the fan control pull-chain switch:
fan off at start.
• First pull: fan on, low speed
• Second pull: medium speed
• Third pull: high speed
• Fourth pull: fan off
3-SPeed • oPtionaL LiGHt Fixture inStaLLation
if you are installing a light kit to an existing fan, follow all
instructions below.
if you are installing the light kit with the fan, skip
Steps 1-5.
1. Remove the switch housing cap by loosening the two
8-32 screws that attach it to the switch housing.
2. loosen the screws securing the switch housing to the
motor. notE: You do not need to remove these screws,
just loosen them enough to turn the housing.
3. Rotate the switch housing so that the screws are aligned
with the larger side of the keyholes.
4. Pull the switch housing away from the motor
assembly.
5. disconnect the switch housing plug connector from the
motor plug connector by pressing down on the handle
of the small clasp and pulling apart.
6. Remove the plug from the switch housing.
7. install the pull-chain switch as follows:
• Remove the collar from the switch
• Thread the pull chain through the hole in the switch
housing
• Place the switch so that the neck protrudes from
the hole
• Thread the collar back over the chain and hand-
tighten the collar on the neck of the switch
8. Thread the two wires from the light kit through the
hole in the center of the switch housing.
9. Connect one wire from the pull-chain switch to the
BluE d1-option wire. Secure the splice with a wire
nut.
10. Connect the other wire from the pull-chain switch to
the BLACK wire from the light kit. Secure the splice
with a wire nut.
11. Connect the WHitE wire from the switch housing to
the WHitE wire from the light kit. Secure the splice
with a wire nut.
notE: if a separate circuit is used to control the lights
from a wall control, the BluE d1-option wire in the
canopy should be connected to that switch leg with the
BLACK fan power wire.
Return to Steps 13b-15 (SWitCH HouSinG
inStallation) to attach (or re-attach) the switch
housing to the motor assembly. Refer to your light kit
instructions to assemble and attach the rest of your light
kit correctly.
using the blade rotation (reversing) pull-chain switch:
Blade rotation controls the airflow direction. Each pull of
the pull-chain switch toggles the blade rotation.
notE: Ceiling fans work best by blowing air downward
(counterclockwise blade rotation) in warm weather to cool
the room with a direct breeze. in cold weather, having
the fan draw air upward (clockwise blade rotation) will
distribute the warmer air trapped at the ceiling around the
room without causing a draft.
light Fixture
Switch hous-
ing plug
light
pull-chain
Switch
collar
wHite
Blue
bLack/bLue