Installing the belt clip, Using the earphone, Installing the belt clip using the earphone – Uniden UBC220XLT User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the Belt Clip
1. Place the Belt Clip on
the mounting area on
the back of the
scanner, making sure
the holes in the clip
line up with the
threads in the back of
the scanner.
2. Insert the 2 screws into the corresponding holes and
tighten.
CAUTION: Do not tighten the screws too tight. You could
damage the case or clip.
Using the Earphone
The PHONE jack at the top of the UBC 220XLT is
a
standard
3,5mm stereo phone jack. You can use either the supplied
earphone, or a stereo headset of the proper impedance (32ii).
The output of this jack is monaural audio , but you will hear it
in both headphones of a stereo headset.
IMPORTANT!
Be sure to use only the supplied earphone, or stereo headset
of the proper impedance (32ii), Use of an incorrect earphone
or stereo headset may be potentially hazardous to your
hearing.
WARNlNGiTo avoid discomfort or possible hear
ing damage, be sure to set the Volume Control
before plugging in the earphone or proper head
phones, A sudden opening of the Squelch may
cause unexpected loud audio.
11