Uniden UBC220XLT - Manual (Page 23)

Search Frequency Skip,
The scanner may stop at certain frequencies during Search
that you do not want to hear. You can program up to 10 Skip
Frequencies into the UBC 220XLT. When the scanner stops at
one of these frequencies during Search, press 070. That
frequency is now "memorised" and wili be skipped during any
Search. The scanner will then search to find other active
frequencies.
Caution: )f you attempt to lock out more than 10
frequencies, you will overwrite those trequencies
already stored in the Search Skip Memory.
To remove L/0 from skipped frequencies, put search on HOLD
then press
(W'] for at least two seconds. You will hear two beeps
and all skipped frequencies are returned to the search cycle once
resumed.
Programming With SEARCH
The Search feature enabies you to rapidly search for active
frequencies within band limits you specify. When an
interesting frequency is found, you can store it in a channel
using the procedure below.
1
.
2
.
3.
Press @.
Use the keypad to select the channel you wish to store
a frequency in.
Press @ to access that channel.
I
4. Use the keypad to enter the lowest frequency of the
band you wish to search.
5. Press
6. Enter the highest frequency of the band you wish to search.
7. Press ^ 1 ^.
8. Press |SRCn|.
9. The channel you chose above will be blinking on the display
10. When Search stops on a desired frequency, press fijaT)
to stay on that frequency.
fBANK
SRCH
mos.oooo
HOLD DLY
11. To store the displayed frequency in that channel, press
The channel number on the display stops blinking.
Repeat this procedure to store other trequencies found in
SEARCH Mode.
21