Uniden UBC220XLT - Manual (Page 27)

Troubleshooting
If your UBC 220XLT is not performing properly, try the steps
listed below.
PROBLEM SOLUTION
1
Scanner won’t work.
Check the power connections.
Check the volume and squelch.
Make sure the power switch is
turned on.
Improper reception.
Check the antenna connection.
You may be in a fringe area.
Reposition the scanner.
Scan won’t stop.
Adjust the Squelch Control.
Check the antenna connection.
It is possible that none of the
programmed frequencies are
active at the time.
Scan won't start.
Make sure there are some
programmed channels.
Adjust the Squelch Control.
Search won’t start.
Adjust the Squelch Control.
Keypad won't work.
Check the Keypad Lock,
I
If you still cannot get satisfactory results and want additional
information, or to return the unit for service, please call or write
the Uniden Technical Service Division. The address and
phone number are listed in the Warranty (at the end of this
manual).
25