Kenwood TH-42A - Manual (Page 49)

2 Press [FI (1 s), [1].
no
ur
3 Turn the ENC/SQL control to select Page memory A.
-
OJf*
4 Enter your station code (000 to 999) using the
numeric keys.
• This entry stores your station code in Page memory
A.
5 Select Page memory 1 to 6 by turning the ENC/SQL
control.
6 Enter a 3-digit group code or individual station code
you wish to program using the numeric keys.
* To restore the frequency display, press [VFO],
[MR], [CALL], [T/CT], or [REV].
7 To Store additional group or individual codes, repeat
Steps 5 and 6.
You can immediately use the group code or individual
station code that was stored or selected last.
CALLING
1 Tune to the prearranged frequency.
2 Press [F], [1] to switch ON Page.
• "PAG" appears.
• Each time this key combination is pressed, Page
toggles ON and OFF.
3 Press [F] (1 s), [1] to select Code Select.
4 Turn the ENC/SQL control to select the Page memory
where the desired group code or individual station
code has been stored.
• If you have not stored the desired Page code in a
memory from 1 to 6, select memory 0 and store the
Page code at this time.
5 Press and hold [PTT], then call the other station after
the code transmission completes.
• The group code (or individual station code) and
your station code are transmitted.
Note:
► When Page is ON, Scan cannot be used.
► When Page is ON, choosing the VFO, the Call channel, or
a memory channel does not affect the Page status. Page
remains ON.
► When Page is switched ON while DTSS is ON, DTSS is
switched OFF automatically.
44