Crestron electronic CLW-SW1/4RF - Manual (Page 16)

infiNET™ Switches Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF
Switch Operation & LED Behavior
LED BEHAVIOR DEVICE STATE
LOW In RUN mode, operating normally
HIGH Device is in the bootloader. Refer to
“Bootloader” on page 29 for more
information.
Four brief OFF blinks every eight
seconds. In RUN mode but there is no
communication with a gateway.
1
Four brief HIGH blinks every eight
seconds. Device failed to acquire with a gateway. 1
Two brief OFF blinks every eight
seconds. In RUN mode, and communicating with a
gateway, but the switch is not addressed
in a control system program.
Blink OFF for ½ second, LOW for ½
second. In SET mode.
Blink OFF for one second, HIGH for
one second. The switch is in the Acquire mode and
searching for a gateway.
Blink OFF for ¼ second, HIGH for
¼ second. In Touch-setup mode (refer to “Use Touch
Settable ID (TSID) to Set MNET ID” on
page 13) and waiting for the user to press
a button to identify device.
2
1. Refer to “Acquire the Switch on the infiNET Network” on page 8.
2. Refer to the Crestron Toolbox help file.
12 • infiNET Switches: Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF Operations Guide - DOC. 6397A