JVC CA-V605T - Manual (Page 3)

INTRODUCTIONS
We would like to thank you for purchasing one of our JVC products.
Before operating this System,
read this manual carefully and
thoroughly to obtain the best possible performance from your System,
and retain this manual for future reference.
About this manual
This manual is organized as follows:
• The manual mainly explains operations using the buttons
and controls on the System. You can also use the buttons
on the remote control if they have the same or similar
names (or marks) as those on the System.
If operation using the remote control is different from that of
using the System, it is then explained.
• Basic and common information that is the same for many
functions is grouped in one place, and is not repeated in
each procedure. For instance, we do not repeat the infor­
mation about turning on/off the System, setting the volume,
changing the sound effects, and others, which are ex­
plained in the section “Common Operations” on page 10.
• The following marks are used in this manual:
CAUTION:
Gives you warnings and cautions to prevent from a damage
or risk of fire or electric shock.
Also gives you information which is not good for obtaining
the best possible performance from the System.
Notes:
Gives you information and hints you had better know.
Precautions____________________
Installation
• Install in a place which is level, dry and neither too hot or too
cold — between 5°C (41 °F) and 35°C (95°F).
• Install the System in a location with adequate ventilation to
prevent internal heat built-up in the System.
• Leave sufficient distance between the System and the TV.
• Keep the speakers away from the TV to avoid interference
with TV.
Power sources
• When unplugging from the wall outlet, always pull the plug,
not the AC power cord.
|— CAUTION------------------------------------------------------
DO NOT handle the AC power cord with wet hands.
Moisture condensation
Moisture may condense on the lens inside the System in the
following cases:
• After starting the heating in the room
• In a damp room
• If the System is brought directly from a cold to a warm place
should this occur, the System may malfunction. In this case,
leave the System turned on for a few hours until the moisture
evaporates, unplug the AC power cord, and then plug it in
again.
Others
• Should any metallic object or liquid fall into the System,
unplug the System and consult your dealer before operat­
ing any further.
• If you are not going to operate the System for an extended
period of time, unplug the AC power cord from the wall
outlet.
r- CAUTION----------------------------------------------------------------
DO NOT disassemble the System since there are no user
serviceable parts inside.
If anything goes wrong, unplug the AC power cord and consult
your dealer.
- CAUTION---------------------------------------------------------------
DO NOT install the System in a location near heat sources,
or in a place subject to direct sunlight, excessive dust or
vibration.