JVC CA-V605T - Manual (Page 39)

TROUBLESHOOTING
Troubleshooting
If you are having a problem with your System, check this list for
a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or
the System has been physically damaged, call a qualified
person, such as your dealer, for service.
Symptom Cause Action
No sound is heard. Connections are incorrect or loose. Check all connections and make
corrections. (See pages 2 to 4.)
Hard to listen to broadcasts
because of noise. • Antennas are disconnected.
• The AM loop antenna is too close to the
System.
• The FM antenna is not properly extended
and positioned.
• Reconnect the antennas correctly and
securely.
• Change the position and direction of the
AM loop antenna.
• Extend the FM antenna at the best
position.
The disc sound is discontinuous. The disc is scratched or dirty. Clean or replace the disc. (See page 1.)
The disc sound loses stereo
effect. The Lch MONO mode is activated. Press KARAOKE on the front panel to
restore the stereo effect.
The pictures from the CD player is
distorted.
When you pause or advance the pictures
manually, the pictures are distorted. This is
not a malfunction.
The disc tray does not open or
close.
The AC power cord is not plugged in. Plug the AC power cord.
The disc does not play. The disc is placed upside down. Place the disc with the label side up.
The cassette holders cannot be
opened.
Power supply from the AC power cord has
been cut off while the tape was running.
Turn on the System.
Impossible to record. Small taps on the back of the cassette are
removed. Cover the holes with adhesive tape.
Operations are disabled. The built-in microprocessor may malfunction
due to external electrical interference.
Unplug the AC power cord and then plug
it back in.
Unable to operate the System
from the remote control.
• The path between the remote control and
the remote sensor on the unit is blocked.
• The batteries are exhausted.
• Remove the obstruction.
• Replace the batteries.
Page 35