JVC TV 13140 - Manual (Page 23)

DUPLICATING A VIDEO TAPE RECEPTION DISTURBANCES
If you connect the TVATCR to another VCR or CAMCORDER, you can duplicate a prevloualy recorded tape.
Make all connections before turning on the power.
Insert a blank cassette with the erase preven*
tton tab intact into the TV/VCR.
Insert a previously recorded cassette into the
playback VCR or Camcorder.
Press the INPUT button twice select AUDIO/
VIDEO input position, Th6 "LINE P will appear
on the screen.
INPUT
NOTE: You can also use the rear AUDIO/VIDEO IN
Jacks. Select "LINE R" by pressing the INPUT
button.
CONNECTION TO ANOTHER VCR
flECORDING TV/VCR
PLAYBACK VCR
%
T
4
VIDEO OUT T АиОЮ OUT
AUDIOfl/IDEO CORD (NOT SUPPUED]
Press the REC bunon and the
PLAY button simultaneously
on the remote control or the
REC button on the TV/VCR, then
press the PAUSE button.
VIDEO IN Vy AUDIO IN
AUDKD/VIDEO CORO
(MOT SUPPLIED)
ToVlOEO^AUOJOJN
Press the PLAY Button on the I
playback VCR. I
Press the PAUSE button
on the TV/VCR to begin
the duplicating process.
NOTE: • It is recommended &iat the tape speed be set to the SP mode on the TV/VCR for best results.
• Unauthorized recording of copyrighted television programs, films, video cassettes and other materials may
infringe the rights of copyright owners and be contrary to copyright laws.
to
CO
42
Most types of television interfarance can be remedied by sdjusting the height and position of the VHFAJHF
antenna. Outdoor antennas are recommended for treat results. The most common types of television Interfer­
ence are shown below. If one of these symptoms appear when the TV/VCR Is connected to a Cable TV system,
the disturbance may be cauaed by the local Cable TV company broadcast.
CONNECTION TO CAMCORDER
For duplicating a prewously recorded tape from a camcorder,
foltovr the camcorder manufacturer's instructions. A typical
camcorder dubbing hookup is shown below.
HECOROING TV/VCR
A-
IGNITION
Black spots or horizontal streaks may appear, the picture may flutter or
drill. Usually caused by interference Irom automobile ignilion systems,
neon lamps or AC powered tools and appliances such as drills or hair
dryers.
GHOSTS
Ghosts are caused by the television signal following two paths. One Is Ihe
direct path and the other is reflected by tall buildings, hills or other large
objects. Changing the direction or position of the antenna may improve the
reception.
SNOW
If the TV/VCR is located far from the TV station, in a fringe reception
area where the signal is weak, small dots may appear in the picture.
If the signal is extremely weak, the installation of a larger external
antenna may be nersessary.
RADIO FREQUENCY INTERFERENCE (RFI)
Caused by two-way radios, this type of interference produces moving
ripples or diagonal streaks in the picture. Some cases may cause a loss of
contrast in the picture. Changing the direction and position of the antenna
or installing an RFI filter may improve the picture.
PICTURE SIZE VARIATION
A slight picture size variation is normal when you adjust the CONTRAST or
BRIGHTNESS settings.
CARE AND MAINTENANCE
To prevent fire or shock hazard, disconnect the TV/VCR from the AC power source before cleaning.
The finish on tfie cabinet may be cleaned with mild soap and a soft, damp cloth and cared for as other furniture. Use
caution when cleaning or wiping the plastic parts.
43